Mason Jar Lifestyle
Foaming Soap Lid Kit
Foaming Soap Lid Kit
Upgrade your bathroom or kitchen with this durable stainless steel foaming soap dispenser pump.This high-quality soap pump lid for Mason jars is made from rust-resistant stainless steel for long-lasting performance.
Perfect for dispensing foaming hand soap or foaming dish soap. Use your favorite pre-made foaming soap or use our simple DIY recipe below.
Kit Includes:
- Stainless steel foaming pump head
- Threaded adapter lid
- Intake straw
1 foaming soap pump lid per order. Jar not included.
Foaming Soap Recipe:
The jar will leak if you tip it on it's side or upside-down while mixing the soap. Consider adding a Leak Proof Silicone Sealing Ring for less leaking.
Create rich, luxurious foaming soap at home in just a few simple steps:
- Mix liquid soap with water using a ratio of 1 part soap to 4–6 parts water. Most liquid soaps work well, but Castile soap produces the best results.
- Fill your jar with warm water and add the soap. Stir gently using the intake straw, or attach a standard storage lid and shake until thoroughly combined.
- Add a few drops of your favorite essential oil for a custom fragrance, if desired.
- Install the foaming pump and enjoy rich, creamy foam with every pump.
Helpful Tips
- Prevent leaks while mixing: The dispenser may leak if the jar is tipped on its side or upside down. For less leaking, consider adding a leak-proof silicone sealing ring.
- Recommended jar sizes: Pint and quart Mason jars work best. The pump and intake tube measure approximately 6 inches long, reaching to about 1 inch from the bottom of a quart jar.
- Trim the intake tube: For optimal performance, cut the tube so it stops just short of the bottom of the jar rather than resting on the bottom.
Troubleshooting:
If your foaming pump isn't dispensing properly, a quick cleaning usually restores normal performance.
Step 1: Clear the Air Chamber
Water can sometimes collect in the pump's air chamber (the plastic housing that contains the spring). Hold the pump upside down and press the pump several times to expel any trapped water.
If soap residue has built up inside the pump, run hot water through it by repeatedly pumping until the water flows clear.
Step 2: Clean the Aeration Filter
If the pump is still not working correctly, the aeration filter may need to be cleaned. This small cylindrical filter is located beneath the pump head. Simply pull the pump head off the base to access it. (Check the photo gallery above for a video showing how to remove it!)
Rinse the filter with warm water, or soak it in a mixture of warm water, baking soda, and vinegar to remove stubborn buildup. You can buy a replacement filter here.
Care Tips
For best performance, flush the pump with hot water between refills. Best practice would be to pump hot water through to clean it out between each refill. I run hot water in the sink and pump that through till it comes out clear.
Couldn't load pickup availability
Share

